Walterr Bugdanavage Apr 18,

large tree may be felled against its natural lean by using the boring technique. Use the open-face notch and bore cut the tree to establish the hinge. Tree removal illawarra NOT CUT OUT THE BACK. Allow enough backwood to keep the tree secure.

Remove the saw from the bore cut and insert wedges tightly into it. Release the tree from the back. Complete the technique by wedging the tree over. This technique is for. Apr 03, In this video Inbred Jed and myself demonstrate 8 different ways to drop a tree and the different applications of the different cutting shrubremoval.bar go over Author: Guilty of Treeson @ Eastside Tree Works.

Tree felling is commonly performed with a chainsaw. Cutting one tree can take a lot of work and planning. First, a person must be prepared. He should begin by developing a plan for how a tree will fall.

A tree should be cut so when it falls it does not come into contact with anything else, including other trees. The basic felling procedure is to cut a notch on the side of the tree toward the direction you want it to fall, using a chain saw, and then finish cutting through the trunk from the opposite side.

Jul 10, If the tree is still upright, then you’ll want to use a felling wedge to make the tree begin to fall. The felling wedge acts as a lever that gives the tree a push in the right direction for it to tip over.

This article has been viewed, times.

Insert the wedge into the back cut and tap it with a sledge hammer until the tree starts to fall. If the Tree Becomes Lodged During the Fall.